Carrhill PRA114 Anodeless Transition Riser 1.25 in Mipt

Product DescriptionThe CARRHILL PRA114 is a 1.25-inch MIPT steel by MDPE anodeless transition riser designed to connect underground medium-density polyethylene (MDPE) gas service lines to above-ground steel piping systems. This fitting bridges the transition from buried plastic gas distribution pipe to a threaded steel service connection without the use of a traditional anode, simplifying installation in low-pressure gas service applications. It is typically installed by licensed plumbers or gas fitters at the point where the service line emerges from the ground at a meter set or appliance service entrance.This transition riser is suited for residential and light commercial natural gas or propane service installations where MDPE polyethylene pipe is run underground and must terminate at a steel threaded connection above grade. The 1.25-inch male iron pipe thread (MIPT) steel end allows direct connection to standard gas meter sets, regulators, or service valves. Applications include new construction gas service installations and replacement or repair of existing riser assemblies at meter locations.Key Features1.25-inch MIPT steel end for direct connection to standard gas meters, regulators, or service valvesMDPE plastic end factory-fused for a leak-resistant transition from underground polyethylene gas pipeAnodeless design eliminates the need for sacrificial anode corrosion protectionSteel upper section provides above-grade mechanical strength and durabilityOrder increment of 1 allows single-unit purchasing for service and repair workCompatibilityDesigned as an OEM-style replacement and new-installation fitting for residential and light commercial natural gas or propane systems using MDPE underground service pipe with above-grade steel threaded connections.Installation NotesInstallation of gas transition risers must be performed by a licensed plumber or qualified gas fitter in accordance with IFGC requirements and all applicable local codes. Shut off and verify gas service is fully depressurized before making any connections. The MDPE end is designed for mechanical or heat-fusion joining depending on the fitting configuration do not use solvent cements on polyethylene gas pipe. Inspect all threaded connections with an approved leak-detection solution before returning the system to service.Technical SpecificationsConnection Size: 1.25 inchesSteel End Thread Type: MIPT (Male Iron Pipe Thread)Pipe Material Upper: SteelPipe Material Lower: MDPE (Medium-Density Polyethylene)Application: Natural gas and propane underground-to-above-grade service transitionOrder Increment: 1Standard InformationBrand: CARRHILLManufacturer Part Number: PRA114